Auto Page MA-200 Manuál s instrukcemi Strana 3

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 56
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 2
colorCONTROL C4
2
Manual
Software colorCONTROL C4 V6.4
(PC software for Microsoft® Windows® Vista, XP, 2000, NT® 4.0, Me, 98, 95)
for color sensors
colorSENSOR OT-3-MA-200-20
colorSENSOR OT-3-GL-200-20
colorSENSOR OT-3-HR-200-20
with internal temperature compensation and white light balancing
This manual describes the installation of the PC software for the colorSENSOR OT-3-...-200-20 color sensor. As a
support for commissioning of the color sensor this manual explains the functional elements of the Windows® user
interface.
The colorSENSOR OT-3-...-200-20 color sensor detects the radiation that is diffusely reflected by the target. The
colorSENSOR OT-3-...-200-20 color sensor uses a white-light LED with adjustable power as a light source. A triple
receiver for the RED, GREEN, and BLUE content of the light reflected from the target is used as a receiver. With
the stepless adjustment of the integrated light source and the selectable gain of the receiver signal the sensor can
be set to almost any surface.
The colorSENSOR OT-3-...-200-20 color sensor can be "taught" up to 31 colors. Tolerances can be set for every
taught color. In X/Y INT or s/i M mode the tolerances represent a color cylinder in space. In X/Y/INT or s/i/M mode
the tolerance represents a color sphere in space. Color evaluation according to s/i M and s/i/M uses the Lab
calculation method. All the modes can be used in combination with various operating modes, among others
"FIRST HIT" and "BEST HIT". The raw data are represented with 12 bit resolution.
Color detection either operates continuously or is started by means of an external SPC trigger signal. The
respective detected color either is output as binary code at the 5 digital outputs, or it can be sent directly to the
outputs, if only up to 5 colors are to be detected. Simultaneously the detected color code is visualised at the
colorSENSOR OT-3-...-200-20 housing by means of 5 LEDs.
With the TEACH button at the sensor housing the sensor can be taught up to 31 colors. For this purpose the
corresponding evaluation mode must be set with the software. The TEACH button is connected in parallel to the
input IN0 (green wire of cable cab-las8/SPS).
Through the RS232 interface parameters and measured values can be exchanged between the PC and the
colorSENSOR OT-3-...-200-20 color sensor. All the parameters for color detection can be stored in the non-volatile
EEPROM of the colorSENSOR OT-3-...-200-20 color sensor. When parameterization is finished the color sensor
continues to operate with the current parameters in "stand alone" mode without a PC.
The sensors of the colorSENSOR OT-3-...-200-20 V6.4 series can be calibrated (white light balancing). Balancing
can be performed to any white surface. A ColorChecker
TM
table with 24 color fields according to CIE standard is
available as an alternative, and white light balancing or calibration can then be performed to one of the white
fields.
Zobrazit stránku 2
1 2 3 4 5 6 7 8 ... 55 56

Komentáře k této Příručce

Žádné komentáře